Table of Contents
Advertisement
Setting of the display colour (CoL)
Press the UP or DOWN button to select the display colour.
: It is a common setting for SP1 to SP3.
Press the SET button to save the setting.
1: A selected item is enabled after the SET button is pressed.
2: After enabling a setting by pressing the SET button, it is possible to return to measurement mode by pressing the SET button for
2 seconds or longer.
3: When setting the output mode, output point, ON width, or hysteresis, if the operating range overlaps with the already set operating
range (SP2, SP3, etc.), it will be an SW output detection range error and an error code (Er3) is displayed.
The set value that caused an error is invalid. Set the value again without causing the operating range to overlap.
Returns to function selection mode.
[F 1] SP1 setting completed
-42-
No.D-※S-OMA1021
Advertisement
Table of Contents
