SMC Networks D-MH1AD Series Operation Manual page 30

You may use an actuator with long stroke by setting a delay time for the sensor monitor (refer to page 41) or
use it in combination with a general purpose switch.
: By setting a delay time on the sensor monitor to pass through the operating range at a high speed, you can set not to cause an output.
(Be sure to configure settings according to the actual operating environment.)
: When using for other purposes such as determination, adjust the mounting position of the analogue ASW so that the workpiece
gripping point, etc. will be close to the 3-V output point (the centre of the determinable range).
: The analogue ASW outputs approximately 3 V at no magnetic field. If an output point is set at close to 3 V for the gripping point, etc.,
the output may turn ON even when the magnet is sufficiently away from there. If this is the case, use a general purpose switch, etc. in
combination and set your equipment to ignore the monitor output if the general purpose switch is ON, and so on.
-29-
No.D-※S-OMA1021