SMC Networks D-MH1AD Series Operation Manual page 47

<The display of the sub display>
•Standard
In the standard display, display items and their values are shown on the sub display.
Select the displayed items by pressing the UP or DOWN button in measurement mode.
: Displayed only in 3 setting mode.
•2 value display
The 2 value display function allows to select and display the items listed below on the right and left side of
the sub display.
List of items for selection
Display item
SP1 output point set value
SP2 output point set value
SP3 output point set value
Peak measurement indication
Bottom measurement indication
NPN or PNP output set value
String of random characters
Display OFF
●: Default setting ○: Selectable
When using the 2 value display function, 3 step setting is not available in that display.
(When setting 3 steps, select each set value to be displayed by pressing the UP or DOWN button.)
If the output setting mode is changed after selecting the 2 value display, there may be no applicable
display items depending on the selection and [- - -] may be displayed. In this case, select items for the
2 value display again.
•Character string display
The character string display function is used to display any characters (line name) on the sub display.
•Display OFF
This setting hides the sub display.
Sub display selection
Details
Left side
×: Not selectable
-46-
Right side
● ○
○ ●
○ ○
Only in 3 setting mode.
○
×
○
×
○ ○
○ ○
○ ○
Remarks
No.D-※S-OMA1021