Replace Pressure Sensor - Nespresso Momento 120 Service Manual

Removing FEP
tubes: → p. 142
186
Repair > Milk Module Repairs (Metal Component Support)

11.14.3 Replace Pressure Sensor

2
1
This component and connected pipes are under pressure (→ p. 15),
follow the instructions on page 140 in advance!
Prerequisites
• Hydraulic unit and PCB assembly are detached → p. 182.
Procedure
1. Remove the FEP tube (A) from the pressure sensor (2).
2. Loosen 1 screw nut (3) from the suction nozzle valve (4) so you can push it to the
side and get easy access to the screw nut (5) of the pressure sensor (1).
3. Loosen the screw nut (5) of the pressure sensor (1) and slide the pressure sensor
(1) out of the holding plate.
4. Cut the cable tie (2) and unplug the connector of the pressure sensor (1).
Assembly tip
• Don't forget to fix the pressure sensor's connector with a cable tie.
Momento 120 Service Manual
3 4
5
A
Fig. 157
Version 1.4 EN