Nespresso Momento 120 Service Manual page 139

7. Loosen 1 screw (TX20) on the brewing unit (1).
8. Slide the brewing unit forward and lift it up at the same time to remove it from
chassis BU (2).
Assembly tips
• Only use the black coloured connector clip for the hose adapter connected dir-
ectly to the thermoblock.
• Always replace the O-ring seated between the thermoblock and hose adapter.
• Always replace the O-rings seated between valves and hose adapters.
• Always replace the O-ring seated between pump connector and pressure hose.
Version 1.4 EN
Repair > Coffee Module Repairs
1
2
Momento 120 Service Manual
The illustration
shown is with the
thermoblock, valves
and pressure hoses
removed – for better
visibility.
Fig. 103
139