1
2
6
4
5
3. Pull the wires out of the guides and wire saddles.
4. Pull off the upper low pressure hose (4) from the flowmeter (5).
5. Pull out the connector clip (1) from the pump connector (2, see detail) with
pointed pliers.
6. Pull off and discard the O-ring (3) between pressure hose and pump connector
(2).
7. Slide the pump (6) out of chassis BU (7).
Assembly tips
• Always replace the O-ring seated between pump connector and pressure hose.
• Do not twist or fold the pressure hose to the flow meter – water must be able to
flow free of resistance.
Version 1.4 EN
3
7
Repair > Coffee Module Repairs
Momento 120 Service Manual
Fig. 88
129