Remove Hydraulic Components Support - Nespresso Momento 120 Service Manual

172
Repair > Milk Module Repairs (Plastic Component Support)

11.13.11 Remove Hydraulic Components Support

1
2
Connected pipes are under pressure (→ p. 15),
follow the instructions on page 140 in advance!
Prerequisites
• Hydraulic unit and PCB assembly are detached → p. 160.
• All connectors are removed from the control board → p. 148.
• Steam pressure regulator is removed → p. 166.
• Tube of the NTC fluid line is removed from the steam chamber → p. 168.
Procedure
1. Push the tube (2) slightly to the side to get access to the screw.
2. Loosen the screw (crosshead) on the back of the hydraulic unit (1).
Momento 120 Service Manual
Fig. 142
Version 1.4 EN