Nespresso Momento 120 Service Manual page 8

8
Content Updates
1 C O N T E N T U P D AT E S
Version 0.1
• Removal of spare parts list/drawings.
• Preliminary service manual version.
Version 0.2
• Draft of all repair procedures added/finalised.
Version 0.3
• Removed the troubleshooting info of the Momento 100/200 service manual and
the Momento 120 user manual.
• Included information from Thermoplan technical manual.
Version 0.4
• Interim version, reordering of installation chapter subsections.
• Implementation of new feedback as far as information is available.
Version 0.5
• Preventive maintenance and software diagnostic menu.
• Added chapter/sub-chapter numbering.
Version 1.0
• Minor adjustments, spelling check, final version for SOP.
Version 1.1
• Milk Pump Calibration procedure.
Version 1.2
• Restructuring for inclusion of plastic component carrier.
• Inclusion of plastic component carrier.
• Several updates and amendments.
• New and more specific change log from this version onward:
Change
Removed error list from Appendix section
Corrected wrong Hz for South Korea
Power rating of complete milk module added to technical data
Added info about necessity for machine to be upright 24h before machine is
switched on after milk module installation
New section "Reinforced Cleaning in Case of Misuse"
Added info about machine blockage if no descaling is performed
Adjusted page references for PM on both component support versions
Added "Cleaning of FEP Tubes and T-Connector" to PM
Reworded "valve motor" to "magnetic coil" for consistency
Change procedure to remove the water coupling (hose fitting stays in tube)
New procedure to replace the air valve (pcs)
Momento 120 Service Manual
Page N° Requested by
- Nespresso
p. 19 Nespresso
p. 19 Nespresso
p. 25 THP
p. 48
Nespresso
p. 51 Nespresso
p. 52 -
p. 53 THP
p. 153
THP
p. 155 THP
p. 165 THP
Version 1.4 EN