Table of Contents
Advertisement
Machine head
3.15 Setting the synchronizer
FIg. 60: Setting the synchronizer
(1) - Cam segment
Proper setting
Once positioned, the thread lever should be approx. 5 mm in front of the
top dead center. The offset edge of the cam segment must then be posi-
tioned at the center between the forks of the light barrier.
To set the synchronizer:
1. Turn the machine to move it approx. 5 mm in front of the Thread lever
2. Loosen the threaded pin (2).
3. Turn the cam segment (1) such that the offset edge of the cam
4. Tighten the threaded pin (2).
5. Check the positioning after cutting.
Service Instructions 745-35-10 B/745-35-10 F - 00.0 - 10/2017
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before setting the
synchronizer.
①
at top dead center position.
segment (1) is at the center between the forks of the light barrier.
(2) - Threaded pin
②
71
Advertisement
Table of Contents
