Table of Contents
Advertisement
Stacker
Fig. 200: Setting the throw-over stacker (4)
(10) - Switch cam
(11) - Switch
The throw-over bracket (3) swivels out.
5. Loosen the screw and set the switch cam (10) by turning.
Important
The throw-over bracket (3) should not reach the end position of the
cylinder (12) during the last section of the backward movement. Check the
optimal switch actuation point with workpieces and correct it if necessary.
Fig. 201: Setting the throw-over stacker (5)
(13) - Switch cam
(14) - Switch
The throw-over bracket (3) swivels down to its end position.
6. Loosen the screw and set the switch cam (13) by turning.
Important
If the switch actuation point is set too early, the throw-over bracket (3) may
collide with the clamping bracket (4) during the last section of the backward
movement. Check the optimal switch actuation point by performing stacking
operations with workpieces and correct it if necessary.
Service Instructions 745-35-10 B/745-35-10 F - 00.0 - 10/2017
⑪
⑩
The switch (11) prevents the throw-over bracket (3) from swiveling
out too far.
The switch (11) should be pressed (b) = 10 - 20 mm before the piston
rod of the cylinder (12) reaches its end position, thereby causing the
throw-over bracket to start swiveling down.
⑭ ⑬
The switch (14) must be actuated (c) = 6 - 8 mm before the end
position of the cylinder is reached.
b
(12) - Cylinder
c
(15) - Cylinder
⑫
⑮
211
Advertisement
Table of Contents
