Aligning The Transport Clamps With The Sliding Plate Edge - DURKOPP ADLER 745-35-10 F Service Instructions Manual

5.1 Aligning the transport clamps with the sliding plate edge

FIg. 71: Aligning the transport clamps with the sliding plate edge (1)
(1) - Transport clamps
Proper setting
The transport clamps (1) must be parallel with the pick-up folder as well as
with the edge of the sliding plate (2).
To align the transport clamps relative to the auxiliary line:
1. Slide the transport clamps (1) into the area of the pick-up folder.
2. Check if the inner edge of the transport clamp and the edge of the
84
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before aligning the transport
clamps with the sliding plate edge.
①
②
sliding plate (2) are parallel to each other.
(2) - Edge of the sliding plate (measuring line)
Service Instructions 745-35-10 B/745-35-10 F - 00.0 - 10/2017
Transport clamps