Table of Contents
Advertisement
Aligning the machine head
10 Aligning the machine head
Fig. 109: Aligning the machine head (1)
(1) - Tabletop
Proper setting
The offset surface (approximately 1.5 mm deeper) of the base plate (2) of
the machine head must be at the same level as the tabletop (1) along its
entire length.
To align the machine head:
1. Slide the transport clamps to the rear.
2. Raise the sliding plate (4) at the front and swivel it out to the left.
3. Check the height of the base plate (2).
Service Instructions 745-35-10 B/745-35-10 F - 00.0 - 10/2017
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before aligning the machine
head.
①
(2) - Base plate
②
125
Advertisement
Table of Contents
