Maintenance - DURKOPP ADLER 745-35-10 F Service Instructions Manual

Maintenance

19 Maintenance
This chapter describes maintenance work that needs to be carried out on
a regular basis to extend the service life of the machine and achieve the
desired seam quality.
Maintenance intervals
Work to be carried out
Machine head
Remove fluff, lint and thread remnants
Checking the oil level
Check the hook lubrication
Check the lenses for the remaining thread monitor
Clean the reflecting foils
Pneumatic system
Check the water level in the pressure controller
Check the filter element in the maintenance unit
Check the tightness of the system
Drive unit and transport carriage
Check state and tension of the toothed belts
Additional equipment
Clean (blow out) the automatic piping cutter
Service Instructions 745-35-10 B/745-35-10 F - 00.0 - 10/2017
WARNING
Risk of injury from sharp parts!
Punctures and cutting possible.
Prior to any maintenance work, switch off the
machine or set the machine to threading mode.
WARNING
Risk of injury from moving parts!
Crushing possible.
Prior to any maintenance work, switch off the
machine or set the machine to threading mode.
Operating hours
8 40 160 500










357