Aligning The Machine Head - DURKOPP ADLER 991-210-10 Series Service Instructions Manual

Working basis

3.5 Aligning the machine head

Fig. 7: Aligning the machine head (1)
(1) - Base plate
(2) - Tabletop
Proper setting
The upper side of the base plate (1) is level with the cutout in the tabletop (2).
Height X of the transport system is identical on the left and the right both at
the rear and the front position of the carriage.
Check the height using the flat material (3).
To align the machine head:
1. Remove the sliding plate.
2. Check the position of the machine head using the flat material (3).
3. Swivel up the machine head ( p. 14).
4. Set the height.
Service Instructions 911-210-10 - 00.0 - 06/2020
①
②
X
(3) - Flat material
③
X
21