Configuring Cpcp Service; Automatic Operator Service; Introduction To Automatic Operator Service - H3C XE 200 User Manual

User Manual
H3C XE 200/2000 IP PBX G-Remote

5.21.2 Configuring CPCP Service

Table 5-28 Configure the CPCP service
Step
1
—
—
—
Return to

5.22 Automatic Operator Service

5.22.1 Introduction to Automatic Operator Service

The automatic operator service enables a subscriber to perform two-stage dialing as
needed. After dialing the access code and establishing a call connection with the XE IP
PBX, the subscriber receives a voice prompt from the XE IP PBX. Then the subscriber
can establish a call connection with the callee, who can provide related service.
Configuration
task
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
configured] in the navigation tree, and
Enable/disable
Select [Call Park and Call Pickup] in the
the CPCP
configuration window to enable the CPCP
service for a
service for the subscriber.
subscriber
Clear this check box to disable the CPCP
service for the subscriber.
Command: srv-switch cpcp (subscriber
number view)
1)
Configure the
lead character
2)
for the XE IP
PBX
Command: leader-character (LS-SRV view)
1)
Configure the
2)
lead character
timeout
Command: match-time (LS-SRV view)
Configure
other call Refer to
services
XE IP PBX Configuration
Chapter 5 Call Service Configuration
Description
Select [System
Server/Service] in the navigation tree.
Specify the lead character in the
configuration window and click <Apply>.
Select [System
Server/Service] in the navigation tree.
Specify the lead character timeout in the
[Match Time] text
configuration window and click <Apply>.
Call Service Overview.
Overview.
5-34
Remarks
Required
View/Location
Optional
View/Location
Optional
box in the
Optional