Table of Contents
Advertisement
User Manual
H3C XE 200/2000 IP PBX G-Remote
Before a user logs onto the GUI server, the GUI server and self-service must be
enabled.
Note:
About details about user classification, refer to
Configure the self-service as follows.
Table 2-5 Configure the self-service
Enter system view
Enter LS view
Enter LS-GW view
Enter subscriber number
view
Enable user self-service
Configure login password
of the user self-service
Note:
The system checks the self-service operation every five minutes. After two system
checks, if still no operation has been performed, the XE IP PBX disconnects a
self-service user.
2.2.6 Configuring Operation Rights of Normal Administrators
For operation rights of normal administrators, refer to
I. Permit/prohibit normal administrators' operations on a specific gateway
This configuration takes effect after a normal administrator logs in through GUI client,
and thus the normal administrator can perform permitted operations.
Table 2-6 Permit/prohibit normal administrators' operations on a specific gateway
Enter system view
Operation
system-view
location-server
gateway gateway-id
subscriber short-number
long-number
srv-switch gui on
gui-pwd
user-log-password
Operation
Chapter 2 GUI Server Configuration
Naming Rule and Rights for
Command
User
Command
system-view
2-4
Users.
Remarks
—
—
—
—
Required
Required
The default login
password is 1234.
Management.
Remarks
—
Advertisement
Table of Contents
