Table of Contents
Advertisement
User Manual
H3C XE 200/2000 IP PBX G-Remote
5.7.2 Configuring Do-Not-Disturb Service
Table 5-9 Configure the do-not-disturb service
Step
1
2
—
Return to
5.8 Calling Line Identification Control Services
5.8.1 Introduction to Calling Line Identification Control Services
The calling line identification control services are used to control whether to display the
caller's number on the callee's phone set.
The services include:
Calling line identification presentation (CLIP)
Calling line identification restriction (CLIR)
Temporary reservation for CLIP and CLIR
Configuration
task
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
Enable/disable
configured] in the navigation tree, and
the
Select [Enable/Disable Do Not Disturb] in
do-not-disturb
the configuration window to enable the
service for a
do-not-disturb service.
subscriber
Clear this check box to disable the
do-not-disturb service.
Command: srv-switch do-not-disturb
(subscriber number view)
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
configured/Services/Do Not Disturb] in the
navigation tree, and
Configure the
Select
do-not-disturb
configuration window to enable the
service
do-not-disturb service.
Clear this check box to disable the
do-not-disturb service.
Command: do-not-disturb (do-not-disturb
service view)
Configure
other call
Refer to
services
XE IP PBX Configuration
Chapter 5 Call Service Configuration
Description
[Do
Not
Disturb]
Call Service
Overview.
Overview.
5-12
Remarks
Required
in
the
Required
Optional
Advertisement
Table of Contents
