Table of Contents
Advertisement
User Manual
H3C XE 200/2000 IP PBX G-Remote
5.26.2 Configuring Alarm Clock Service
Table 5-33 Configure the alarm clock service
Step
1
—
—
Configuratio
n task
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
Enable/disabl
configured] in the navigation tree, and
e the alarm
Select [Alarm] in the configuration window
clock service
to enable the CPCP service for the
for a
subscriber.
subscriber
Clear this check box to disable the CPCP
service for the subscriber.
Command: srv-switch alarm (subscriber
number view)
1)
Select
Server/Gateway/the gateway where the
subscriber
located/Subscriber/the subscriber to be
Configure a
configured/Services/Alarm]
one-off alarm
navigation tree.
clock task by
2)
Select
specifying the
configuration window.
date and time
3)
Specify the date and time in the [XE
System Date] and [XE System Time] spin
boxes respectively.
Command: alarm (alarm clock view)
1)
Select
Server/Gateway/the gateway where the
subscriber
located/Subscriber/the subscriber to be
configured/Services/Alarm]
navigation tree.
Configure a
2)
Select [No Specified Date] in the
one-off or
configuration window.
cyclic alarm
3)
Specify the alarm time in the [XE System
clock task by
Time] spin box and specify the alarm
specifying the
clock type as follows:
time only
Select [Once (Today)] to set a one-off
alarm clock task.
Select [Cycle] to set a cyclic alarm clock
task.
Command: alarm (alarm clock view)
Chapter 5 Call Service Configuration
Description
[System
to
be
[Specified
Date]
[System
to
be
5-42
Remarks
Required
View/Location
configured
is
in
the
Required
in
the
View/Location
configured
is
in
the
Required
Advertisement
Table of Contents
