Configuring Abbreviated Dialing Service; Do-Not-Disturb Service; Introduction To Do-Not-Disturb Service - H3C XE 200 User Manual

User Manual
H3C XE 200/2000 IP PBX G-Remote

5.6.2 Configuring Abbreviated Dialing Service

Table 5-8 Configure the abbreviated dialing service
Step
1
—
Return to

5.7 Do-Not-Disturb Service

5.7.1 Introduction to Do-Not-Disturb Service

The do-not-disturb service is used to refuse incoming calls temporarily. A subscriber
can register for the do-not-disturb service to deny all incoming calls while making
outgoing calls freely.
Configuration
task
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
Enable/disable
configured] in the navigation tree, and
the
Select
abbreviated
configuration window to enable the
dialing service
abbreviated dialing service.
for a
subscriber
Clear this check box to disable the
abbreviated dialing service.
Command: srv-switch adi (subscriber
number view)
Configure
other call Refer to
services
XE IP PBX Configuration
Chapter 5 Call Service Configuration
Description
[Dial Abbreviation]
Call Service Overview.
Overview.
5-11
Remarks
in the
Required
Optional