H3C XE 200 User Manual page 100

User Manual
H3C XE 200/2000 IP PBX G-Remote
I. Local group notification service
The administrator defines a local group notification task.
When the preset time comes, the XE IP PBX will automatically initiate a call to all
subscribers in the specified group. The called subscribers can pick up their phones and
listen to the notification played by the XE IP PBX.
To define a task, the administrator needs to specify the following parameters:
Media file that the task plays.
Time when the notification is sent.
Receiver group of the notification.
Access code that receivers use to hear the notification.
Interval at which the notification is sent again if it fails.
Subscribers that miss the notification can dial the access code to listen to the
notification after the task is executed.
II. Remote group notification service
The administrator defines a remote group notification task. When the task is started, the
notification deliverer can dial the access code to invite all receivers in the specified
group to receive the notification. After any receiver picks up the phone, the deliverer
can start sending the notification.
To define a task, the administrator needs to specify the following parameters:
Receiver group of the notification.
Access code that the deliverer uses to send the notification.
Access code that receivers use to hear the notification.
Interval at which the notification is sent again if it fails.
When the notification is played, phones that are not picked up will keep ringing. The
corresponding subscribers can pick up the phone to listen to the playing notification.
After hanging up when listening to the notification, a subscriber can resume
notification-listening by dialing the access code.
However, after the deliverer hangs up, all receivers stop receiving the notification and
none of them can listen to it again by dialing the access code.
Chapter 5 Call Service Configuration
5-36