Table of Contents
Advertisement
User Manual
H3C XE 200/2000 IP PBX G-Remote
5.15.2 Configuring Callback-On-Busy
Table 5-22 Configure the callback-on-busy service
Step
1
—
—
—
Return to
5.16 Call Pickup Service
5.16.1 Introduction to Call Pickup Service
When subscriber A calls subscriber B, whose phone then rings, subscriber C using the
call pickup service can answer the call by dialing the access code and subscriber B's
phone number. In this way, subscriber C can have a conversation with subscriber A. In
Configuration
task
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
configured] in the navigation tree, and
Enable/disable
the
callback-on-busy
service for a
subscriber
Command: srv-switch cb (subscriber
number view)
1)
2)
Configure the
call back interval
The call back interval is counted in
minutes.
Command: interval (call back view)
1)
Configure the
2)
call back retry
times
Command: retry (call back view)
Configure other
Refer to
call services
XE IP PBX Configuration
Chapter 5 Call Service Configuration
Description
Select [Call Back] in the configuration
window to enable the callback-on-busy
service for the subscriber.
Clear this check box to disable the
callback-on-busy
service
subscriber.
Select
[System
Server/Service/Call
navigation tree.
Set the call back interval in the
[Interval] text box in the configuration
window.
Select
[System
Server/Service/Call
navigation tree.
Set the call back retry times in the
[Retry
Times]
text
configuration window.
Call Service
Overview.
Overview.
5-28
Remarks
Required
for
the
View/Location
Back]
in
the
Optional
View/Location
Back]
in
the
Optional
box
in
the
Optional
Advertisement
Table of Contents
