Table of Contents
Advertisement
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 152. Removing the left control panel
Next steps
1.
Replace the left control
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan cage
6.
Remove the side wall
Steps
1. Align and slide the left control panel in the slot on the system.
2. Route the left control panel cable through the side wall of the system.
3. Align and slide the left control panel cable cover in the slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the left control panel cable to the connector on the system board.
5. Using the Phillips #1 screwdriver, tighten the screws to secures the left control panel and the cable cover to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
panel.
Safety
Before working inside your
cover.
shroud.
assembly.
bracket.
instructions.
system.
Installing and removing system components
179
Advertisement
Table of Contents
