Figure 113. Installing the VGA port
3. Connect the VGA port cable to the LC rear I/O board.
4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated
on the system board connector.
6. Tighten the captive screws on the system.
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Optional BOSS-N1 module
Removing the BOSS-N1 module blank
Prerequisites
Follow the safety guidelines listed in the
Steps
Use a screwdriver to push out the blank from the BOSS-N1 module bay.
After working inside your
Safety
instructions.
system.
Installing and removing system components
145