Table of Contents
Advertisement
Next steps
Replace the left control
panel.
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Route the control panel cable and the VGA cable through the cable clip, the guide slots in the system and connector on
system board.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Close and secure the cable guiding latch.
3. Align and insert the left control panel assembly in the slot on the system.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the left control panel assembly to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 131. Installing the left control panel
Next steps
1.
Replace the cooling fan cage
2.
Replace the air
shroud.
3.
Replace the drive backplane
4. Follow the procedure listed in the
164
Installing and removing system components
Safety
instructions.
Before working inside your
assembly.
cover.
After working inside your
system.
system.
Advertisement
Table of Contents
