Installing The Processor - Dell PowerEdge R760xa Installation And Service Manual

Table of Contents

Advertisement

Next steps
Replace the
processor.

Installing the processor

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the processor heat sink module
Steps
1. Place the processor in the processor tray.
NOTE:
Ensure the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Place the retaining clip on top of the processor in the processor tray aligning pin 1 indicator on the processor.
NOTE:
Ensure the pin 1 indicator on the bracket is aligned with the pin 1 indicator on the processor before placing the
retaining clip on the processor.
NOTE:
Before you install the heat sink, ensure to place the processor and retaining clip in the tray.
Figure 65. Installing the retaining clip
3. Align the processor with retaining clip, by using the fingers press the retaining clip on all the four sides until it clicks into
place.
NOTE:
Ensure the processor is securely latched to the retaining clip.
Safety
instructions.
Before working inside your
or
Remove the liquid cooling
system.
module.
Installing and removing system components
103

Advertisement

Table of Contents
loading

This manual is also suitable for:

E102s

Table of Contents