Table of Contents
Advertisement
NOTE:
Ensure that the PHM is held parallel to the system board to prevent damaging the components.
Figure 70. Installing the processor heat sink
3. Set the anti-tilt wires to the locked position (outward position), and then using the Torx T30 tool, tighten the captive buts
on the PHM in the order below:
a. In a random order, tighten the first nut three turns.
b. Tighten the nut diagonally opposite to the nut you tighten first.
c. Repeat the procedure for the remaining two nuts.
d. Return to the nut screw to tighten it completely.
e. Check all the nuts to ensure they are firmly secured.
Installing and removing system components
107
Advertisement
Table of Contents
