Installing The Left Control Panel; Removing The Right Control Panel - Dell 7HT3R Installation And Service Manual

Installing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the front bezel.
4. Remove the backplane
5. Remove the air shroud.
Steps
1. Route the control panel cable through the cable clip, the guide slots in the system and connector on system board.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Close and secure the cable guiding latch.
3. Align and insert the left control panel assembly in the slot on the system.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the left control panel assembly to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 129. Installing the left control panel
Next steps
1. Install the air shroud.
2. Install the backplane cover.
3. Install the front bezel.
4. Follow the procedure listed in

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
126 Installing and removing system components
Safety instructions.
Before working inside your
cover.
After working inside your
Safety instructions.
system.
system.