Figure 44. Installing a NVMe drive blank
Next steps
1.
Install all
drives.
2. If removed,
install the front
3. If removed,
install the drive
4. If removed,
install the drive backplane
PERC module
Removing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. Disconnect all the cables from rear mounting front PERC module, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide out the rear mounting front PERC module to disengage from the connector on the drive backplane.
82
Installing and removing system components
bezel.
backplane.
cover.
Safety
instructions.
Before working inside your
cover.
system.