Removing The Expansion Card Risers - Dell PowerEdge R760xa Installation And Service Manual

Table 76. Config 1. RF1B+RF2B+R1V+R4T (continued)
Card type
Mellanox (NIC: NDR200)
Mellanox (NIC: NDR)
Mellanox (NIC: HDR100 VPI)
Mellanox (NIC: 100Gb)
Broadcom (NIC: 100Gb)
Intel (NIC: 100Gb)
Intel (NIC: 25Gb)
Broadcom (NIC: 25Gb)
Mellanox (NIC: 25Gb)
Broadcom (HBA:FC64)
Broadcom (HBA: FC32)
Qlogic (Marvell) (HBA: FC32)
Broadcom (NIC: 10Gb)
Intel (NIC: 10Gb)
Intel (NIC: 1Gb)
Broadcom (NIC: 1Gb)

Removing the expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the cables from the expansion card or system board.
NOTE: Only Riser 1 and Riser 4 are supported.
WARNING: If BOSS-N1 module is installed, ensure to disconnect the BOSS-N1 power cable before removing riser
3 blank, Riser 1 or Riser 4.
Figure 81. Disconnecting the BOSS-N1 power cable
Slot priority
1
1
2, 7, 1
2, 7, 1
2, 7, 1
2, 7, 1
2, 7, 1
2, 7, 1
2, 7, 1
2, 7, 1
2, 7, 1
1
2, 7, 1
2, 7, 1
2, 7, 1
2, 7, 1
Safety instructions.
Before working inside your
Maximum number of cards
1
1
3
3
3
3
3
3
3
3
3
1
3
3
3
3
system.
Installing and removing system components 119