Intrusion Switch; Removing The Intrusion Switch Module; Installing The Intrusion Switch Module - Dell PowerEdge R760xa Installation And Service Manual

Intrusion switch

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent cables from being pinched or crimped.
Steps
1. Disconnect the intrusion switch cable from the connector on the rear I/O board.
2. Using a Phillips #1 screwdriver, loosen the screw on the intrusion switch module.
3. Slide the intrusion switch module out of the slot on the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 132. Removing the intrusion switch module
Next steps
1. Replace the intrusion switch

Installing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
160 Installing and removing system components
Safety instructions.
Before working inside your
risers.
module.
Safety instructions.
Before working inside your
system.
system.