Installing The Right Control Panel - Dell PowerEdge R760xa Installation And Service Manual

NOTE: Observe the routing of the cable as you remove the right control panel from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 150. Removing the right control panel
Next steps
1. Replace the right control

Installing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Align and slide the right control panel into the slot on the system.
2. Route the right control panel cable through the side wall of the system.
3. Align and slide the right control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the right control panel cable and VGA cable to the connectors on the system board.
5. Using the Phillips #1 screwdriver, tighten the screws that secures the right control panel and the cable cover to the system.
panel.
Safety
Before working inside your
cover.
shroud.
assembly.
bracket.
instructions.
system.
Installing and removing system components 177