Table of Contents
Advertisement
Figure 46. Installing the rear mounting front PERC module
Next steps
1. Connect all the cables to rear mounting front PERC module.
NOTE:
Route the cables properly to prevent the cables from being pinched or crimped.
2.
Install the drive backplane
3. Follow the procedure listed in
Drive backplane
This is a service technician replaceable part only.
Drive backplane
Depending on your system configuration, the drive backplanes that are supported are listed here:
Table 62. Supported backplane options
System
PowerEdge R760xa
84
Installing and removing system components
cover.
After working inside your
system.
Supported hard drives options
2.5-inch (x 8) NVMe backplane
2.5-inch (x 8) SAS, or SATA backplane
Advertisement
Table of Contents
