Dell PowerEdge R760xa Installation And Service Manual page 105

Table of Contents

Advertisement

6. For new heat sink, remove the Thermal Interface Material (TIM) protective film from the base of heat sink.
Figure 68. Removing the Thermal Interface Material (TIM) protective film
7. Place the heat sink on the processor and press the base of the heat sink until the retaining clip locks onto the heat sink at all
the four corners.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE:
● Ensure latching features on retaining clip and heat sink are aligned during assembly.
● Ensure that the pin 1 indicator on the heat sink is aligned with the pin 1 indicator on the retaining clip before placing
the heat sink onto the retaining clip.
Installing and removing system components
105

Advertisement

Table of Contents
loading

This manual is also suitable for:

E102s

Table of Contents