Idrac Quick Sync 2 Indicator Codes; Idrac Direct Led Indicator Codes - Dell PowerEdge R760xa Installation And Service Manual

iDRAC Quick Sync 2 indicator codes

iDRAC Quick Sync 2 module (optional) is located on the left control panel front IO panel of the system.
Table 87. iDRAC Quick Sync 2 indicators and descriptions
iDRAC Quick Sync 2 indicator code
Off (default state)
Solid white
Blinks white rapidly
Blinks white slowly
Blinks white five times rapidly and then
powers off
Solid amber
Blinking amber

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC
subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or
tablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following table
describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 88. iDRAC Direct LED indicator codes
iDRAC Direct LED indicator code
Solid green for two seconds
Blinking green (on for two seconds and off for two seconds)
LED Indicator off
Condition
Indicates that the iDRAC Quick Sync 2
feature is powered off. Press the iDRAC
Quick Sync 2 button to power on the
iDRAC Quick Sync 2 feature.
Indicates that iDRAC Quick Sync 2 is
ready to communicate. Press the iDRAC
Quick Sync 2 button to power off.
Indicates data transfer activity.
Indicates that firmware update is in
progress.
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Indicates that the system is in fail-safe
mode.
Indicates that the iDRAC Quick Sync 2
hardware is not responding properly.
Condition
Indicates that the laptop or tablet is connected.
Indicates that the laptop or tablet connected is recognized.
Indicates that the laptop or tablet is unplugged.
Corrective action
If the LED fails to power on, reseat the
left control panel flex cable and check.
If the problem persists, see the
help section.
If the LED fails to power off, restart the
system. If the problem persists, see the
Getting help section.
If the indicator continues to blink
indefinitely, see the
If the indicator continues to blink
indefinitely, see the
Check if iDRAC Quick Sync 2
feature is configured to be disabled
by iDRAC. If the problem persists,
see the Getting help
www.dell.com/poweredgemanuals
Dell OpenManage Server Administrator
User's Guide at
openmanagemanuals.
Restart the system. If the problem
persists, see the
Restart the system. If the problem
persists, see the
System diagnostics and indicator codes
Getting
Getting help section.
Getting help section.
section.
or
https://www.dell.com/
Getting help section.
Getting help section.
195