Table of Contents
Advertisement
NOTE:
Refer to
cable routing
Steps
1. Press the release tab to disengage the drive backplane from the hooks on the system.
2. Lift and pull the drive backplane out of the system.
NOTE:
To avoid damaging the backplane, remove the disconnected backplane cables from the cable routing clips before
removing the backplane.
Figure 49. Removing the drive backplane
Next steps
1.
Replace the drive
backplane.
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan cage
6.
Remove the
drives.
7. If required,
remove the rear mounting front PERC
8. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
86
Installing and removing system components
section for more information.
Safety
instructions.
Before working inside your
cover.
shroud.
assembly.
module.
system.
Advertisement
Table of Contents
