Table of Contents
Advertisement
Figure 62. Removing a heat sink
Next steps
If you are removing a faulty heat sink,
Removing the processor
Prerequisites
WARNING:
Remove the processor from processor and heat sink module (PHM) only if you are replacing the
processor or heat sink.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4.
Removing the processor and heat sink module
CAUTION:
You may find the CMOS battery loss or CMOS checksum error displayed during the first instance of
powering on the system after the processor or system board replacement which is expected. To fix this, simply
go to setup option to configure the system settings.
Steps
1. Place the heat sink with the processor side facing up.
replace the heat
sink, if not,
Safety
instructions.
Before working inside your
or
Removing the liquid cooling
remove the
processor.
system.
module.
Installing and removing system components
101
Advertisement
Table of Contents
