Table of Contents
Advertisement
Steps
1. Align the guide rails on the cooling fan cage assembly with the guides on the system.
2. Lower the cooling fan cage assembly into the system until seated firmly.
3. Lower the blue release levers and press to lock the cooling fan cage assembly into the system.
Figure 32. Installing the cooling fan cage assembly
Next steps
1. If removed,
install the air
2. Insert the cables into cables access latch and close cable access latch.
3. Connect the cables to system board that pass through the cooling fan cage assembly cable latch.
4. Follow the procedure listed in
Removing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
Press the orange release tab and lift the cooling fan to disconnect the fan from the connector on the system board.
WARNING:
Ensure not to tilt or rotate the cooling fan while removing from the system.
shroud.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
71
Advertisement
Table of Contents
