Table of Contents
Advertisement
Figure 110. Removing the Serial COM port
5. Install the filler bracket if not replacing the serial COM port.
Next steps
1.
Replace the serial COM
Installing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2. Slide the serial COM port into the expansion card riser and close the latch.
142
Installing and removing system components
port.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
