Table of Contents
Advertisement
Steps
1. Using the Phillips 1 screwdriver, remove the screws that secure the left control panel and the cable cover to the system.
2. Disconnect the control panel cable from the connector on the system board.
3. Holding the cable, slide the left control panel out of the system.
NOTE:
Observe the routing of the cable as you remove the left control panel from the system.
Figure 162. Removing the left control panel
Next steps
Replace the left control
panel.
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Align and slide the left control panel in the slot on the system.
2. Route the left control panel cable through the side wall of the system.
3. Align and slide the left control panel cable cover in the slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips 1 screwdriver, tighten the screws to secure the left control panel and the cable cover to the system.
5. Connect the left control panel cable to the connector on the system board .
Safety
instructions.
Before working inside your
system.
Installing and removing system components
175
Advertisement
Table of Contents
