Table of Contents
Advertisement
68
1-2. Child safety
Run the seat belt through the
4
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted.
Fully extend the shoulder belt
5
and allow it to retract to put it
in lock mode. In lock mode,
the belt cannot be extended.
While
6
restraint system into the sec-
ond seat or the third out-
board seat (if equipped),
allow the shoulder belt to
retract until the child restraint
system is securely in place.
After the shoulder belt has
retracted to a point where there
is no slack in the belt, pull the
belt to check that it cannot be
extended.
If the child restraint has a top tether strap, follow the child
7
restraint manufacturer's operation manual regarding the installa-
tion, using the top tether strap to latch onto the top tether strap
anchor. (P. 75)
After installing the child restraint system, rock it back and forth to
8
ensure that it is installed securely. (P. 71)
LC200_OM_OM60T03U_(U)
pushing
the
child
Advertisement
Table of Contents
