Table of Contents
Advertisement
104
2. Instrument cluster
Drive information
Items displayed can be switched by operating
Drive information
■
4 of the following items can be registered and displayed as the
drive information 1 and the drive information 2 (2 items on each
screen).
Refer to P. 106 for the registration method of the drive information 1
and the drive information 2.
●
Current fuel consumption (bar type/value type)
Displays the current rate of fuel consumption.
● Average fuel consumption (after reset
Displays the average fuel consumption since the function was reset, the
engine was started, and the vehicle was refueled, respectively.
● Average vehicle speed (after reset
Displays the average vehicle speed since the function was reset and the
engine was started, respectively.
● Elapsed time (after reset
Displays the elapsed time since the function was reset and the engine
was started, respectively
● Distance (driving range/after start)
Displays the estimated maximum distance that can be driven with the
quantity of fuel remaining and the distance driven after the engine was
started respectively.
• This distance is computed based on your average fuel consumption.
As a result, the actual distance that can be driven may differ from that
displayed.
• When only a small amount of fuel is added to the tank, the display
may not be updated.
When refueling, turn the engine switch off. If the vehicle is refueled
without turning the engine switch off, the display may not be updated.
*
1
: Use the displayed average fuel consumption as a reference.
*
2
: The function can be reset by pressing
when the item to reset is displayed. If there is more than one item that can
be reset, the item selection screen will appear.
LC200_OM_OM60T03U_(U)
*
2
/after start/after refuel)
*
2
/after start)
*
2
/after start)
for longer than 1 second
up and down.
*
1
Advertisement
Table of Contents
