Table of Contents
Advertisement
446
5-4. Using the other interior features
Test the HomeLink
4
grammed button and observing the indicator light:
● Indicator light illuminates: Programming of a fixed code device
has completed. The garage door or other device should oper-
ate when a HomeLink
● Indicator light flashes rapidly: The garage door opener motor
or other device is equipped with a rolling code. To complete
programming, firmly press and hold the HomeLink
2 seconds then release it.
● If the garage door or other device does not operate, proceed
to "Programming a rolling code system".
Repeat the steps above to program another device for any of the
5
remaining HomeLink
Programming a rolling code system
■
2 or more people may be necessary to complete rolling code pro-
gramming.
Locate the "Learn" or "Smart"
1
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire
is attached to the unit. The
name and color of the button
may
vary
Refer to the owner's manual
supplied with the garage door
opener motor for details.
Press
2
"Learn" or "Smart" button.
Perform
onds after performing
LC200_OM_OM60T03U_(U)
®
operation by pressing the newly pro-
®
button is pressed and released.
®
buttons.
by
manufacturer.
and
release
the
within 30 sec-
3
.
2
®
button for
Advertisement
Table of Contents
