■
Changing the door unlock function setting
It is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the engine switch off.
1
When the indicator light on the key surface is not on, press and hold
2
or
for approximately 5 seconds while pressing and holding
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step
Multi-information
display
To prevent unintended triggering of the alarm, unlock the doors using the
wireless remote control and open and close a door once after the settings
have been changed. (If a door is not opened within 60 seconds after
pressed, the doors will be locked again and the alarm will automatically be
set.)
In a case that the alarm is triggered, immediately stop the alarm. (P. 87)
LC200_OM_OM60T03U_(U)
3-2. Opening, closing and locking the doors
.)
2
Unlocking function
Holding the driver's door
handle unlocks only the
driver's door.
Holding a passenger's door
handle
unlocks
all
doors.
Holding
a
door
handle
unlocks all the doors.
Beep
Exterior:
Beeps
times
Interior: Pings once
the
Exterior: Beeps twice
Interior: Pings once
123
.
3
3
is