Table of Contents
Advertisement
360
4-5. Using the driving support systems
If you notice any symptoms
■
If you notice any of the following symptoms, refer to the likely cause
and the solution, and re-check.
If the symptom is not resolved by the solution, have the vehicle
inspected by your Toyota dealer.
The image is difficult to see
• The vehicle is in a dark area
• The temperature around the lens
is either high or low
• The outside temperature is low
• There are water droplets on the
camera
• It is raining or humid
• Foreign matter (mud etc.) is
adhering to the camera
• Sunlight or headlights are shining
directly into the camera
• The vehicle is under fluorescent
lights,
sodium
lights, etc.
The image is blurry
Dirt or foreign matter (such as water
droplets, snow, mud, etc.) is adher-
ing to the camera
The image is out of alignment
The camera or surrounding area has
received a strong impact
The guide lines are very far out of alignment
The camera position is out of align-
ment
• The vehicle is tilted (there is a
heavy load on the vehicle, tire
pressure is low due to a tire punc-
ture, etc.)
• The vehicle is used on an incline
LC200_OM_OM60T03U_(U)
Likely cause
lights,
mercury
Solution
Drive while visually checking the
vehicle's surroundings. (Use the
Multi-terrain Monitor again once
conditions have been improved.)
The image on the rear view monitor
system screen can be adjusted,
refer to the "NAVIGATION SYSTEM
OWNER'S MANUAL".
Flush the camera with a large quan-
tity of water and wipe the camera
lens with a soft and wet cloth.
Have the vehicle inspected by your
Toyota dealer.
Have the vehicle inspected at your
Toyota dealer.
If this happens due to these causes,
it does not indicate a malfunction.
Drive while visually checking the
vehicle's surroundings.
Advertisement
Table of Contents
