Table of Contents
Advertisement
234
4-3. Operating the lights and wipers
■
Temporary lowering sensor sensitivity
The sensitivity of the sensor can be temporarily lowered.
Vehicles without PCS (Pre-Collision System):
To lower the sensitivity, push and hold
15 to 20 seconds, and release. The indicator light on the inside rear view mir-
ror will flash to indicate that the sensitivity has been lowered.
When the engine switch is turned off, the sensitivity will be returned to its nor-
mal level.
Vehicles with PCS (Pre-Collision System):
Turn the engine switch off while the following conditions are met.
1
• The headlight switch is in
• The headlight switch lever is in low beam position.
Turn the engine switch to IGNITION ON mode.
2
Within 30 seconds after
3
the high beam position then pulling it to the low beam position quickly 10
times, then leave the lever in high beam position.
Automatic High Beam (headlights) may turn on even the vehicle is stopped.
LC200_OM_OM60T03U_(U)
on the inside rear view mirror for
.
, repeat pushing the headlight switch lever to
2
Advertisement
Table of Contents
