Toyota Land Cruiser 200 2021 Manual page 238

238
4-3. Operating the lights and wipers
The sensor sensitivity can be adjusted when "AUTO" is selected.
Increases the sensitivity
5
Decreases the sensitivity
6
7
Pulling the lever operates the
wipers and washer.
After operating several times,
the wipers operate one more
time after a short delay to pre-
vent dripping.
■
The windshield wiper and washer can be operated when
The engine switch is in IGNITION ON mode.
■ Raindrop sensor (vehicles with rain-sensing windshield wipers)
●
The raindrop sensor judges the amount
of raindrops.
An optical sensor is adopted. It may not
operate properly when sunlight from the
rising or setting of the sun intermittently
strikes the windshield, or if bugs etc. are
present on the windshield.
●
If the wiper switch is turned to the "AUTO" position while the engine switch is
in IGNITION ON mode, the wipers will operate once to show that "AUTO"
mode is activated.
●
When the sensor sensitivity ring is turned toward high while in "AUTO"
mode, the wipers will operate once to indicate that the sensor sensitivity is
enhanced.
●
If the temperature of the rain drop sensor is 185F (85C) or higher, or -22F
(-30C) or lower, the automatic operation may not occur. In this case, oper-
ate the wipers in any mode other than "AUTO".
LC200_OM_OM60T03U_(U)
Washer/wiper dual
operation