Starting the engine
Ensure that the shift lever is in P and depress the brake pedal.
1
Touch the area behind the but-
2
tons on the electronic key to the
engine switch.
When
the
detected, a buzzer sounds and the
engine switch will turn to IGNITION
ON mode.
When the smart key system is
deactivated in customization set-
ting, the engine switch will turn to
ACCESSORY mode.
Firmly depress the brake pedal and check that
3
the multi-information display.
Press the engine switch.
4
In the event that the engine still cannot be started, contact your Toyota
dealer.
■
Stopping the engine
Shift the shift lever to P and press the engine switch as you normally do when
stopping the engine.
■
Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery is depleted.
(P. 499)
■
Alarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set,
the alarm may be triggered. (P. 87)
■
Changing engine switch modes
Release the brake pedal and press the engine switch in
engine does not start and modes will be changed each time the switch is
pressed. (P. 213)
■
When the electronic key does not work properly
●
Make sure that the smart key system has not been deactivated in the cus-
tomization setting. If it is off, turn the function on.
(Customizable features: P. 594)
●
Check if battery-saving mode is set. If it is set, cancel the function.
(P. 140)
LC200_OM_OM60T03U_(U)
7-2. Steps to take in an emergency
electronic
key
is
561
is shown on
step above. The
3
7