160
3-3. Adjusting the seats
Third center seat (if equipped)
Pull the head restraint up while pressing
the lock release button.
Third outboard seats (if equipped)
Push a flathead screwdriver into the
1
slot.
The slot is located on the left side of the
left head restraint anchor.
While pressing in the flathead screwdriver, pull up the head restraint.
2
■
Installing the head restraints
Align the head restraint with the installation holes.
1
Push down the head restraint to the lock position.
2
■
When not using the third center seat head restraint (if equipped)
Open the zipper on the back of the third
seat and stow the head restraint inside.
WARNING
■
Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to
do so may result in death or serious injury.
●
Use the head restraints designed for each respective seat.
●
Adjust the head restraints to the correct position at all times.
●
After adjusting the head restraints, push down on them and make sure
they are locked in position.
●
Do not drive with the head restraints removed.
LC200_OM_OM60T03U_(U)
Lock release button