Table of Contents
Advertisement
66
1-2. Child safety
Child restraint system fixed with a seat belt
A child restraint system for a small child or baby must itself be prop-
erly restrained on the seat with the lap portion of the lap/shoulder belt.
◆
Installing child restraint system using a seat belt (child
restraint lock function belt)
Install the child restraint system in accordance to the operation
manual enclosed with the child restraint system.
Rear-facing — Infant seat/convertible seat
■
Adjust the second seat or the third outboard seat (if equipped)
1
If there is a gap between the child seat and the seatback, adjust the
seatback angle until good contact is achieved.
Place the child restraint sys-
2
tem on the second seat or
the third outboard seat (if
equipped) facing the rear of
the vehicle.
Run the seat belt through the
3
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted.
Fully extend the shoulder belt
4
and allow it to retract to put it
in lock mode. In lock mode,
the belt cannot be extended.
LC200_OM_OM60T03U_(U)
Advertisement
Table of Contents
