Table of Contents
Advertisement
258
4-5. Using the driving support systems
Changing settings of the pre-collision system
Disabling the pre-collision system
■
Press the PCS switch for 3 sec-
onds or more.
The PCS warning light will turn
on and a message will be dis-
played on the multi-information
display.
To enable the system, press the
PCS switch again.
The system is enabled each
time the engine switch is turned
to IGNITION ON mode.
Changing the pre-collision warning timing
■
Press the PCS switch to display the current warning timing on the
multi-information display. Each time the PCS switch is pressed with
the warning timing displayed, the warning timing will change as fol-
lows.
The operation timing setting is retained when the engine switch is
turned off.
Far
1
The warning will begin to oper-
ate earlier than with the default
timing.
Middle
2
This is the default setting.
Near
3
The warning will begin to oper-
ate later than with the default
timing.
LC200_OM_OM60T03U_(U)
Advertisement
Table of Contents
